General Machinist

General Machinist
By:Ontario. Ministry of Training, Colleges and Universities
Published on 2008-01-01 by

|This new curriculum standard for the Level 2 - General Machinist for the Machining and Tooling trades is based upon the on-the-job performance objectives, located in the industry approved training standard. The curriculum is organized into 8 reportable subjects. The Program Summary of Reportable Subjects chart summarizes the training hours for each reportable subject. The curriculum identifies only the learning that takes place off-the-job. The in-school program focuses primarily on the theoretical knowledge and the essential skills required to support the performance objectives of the Apprenticeship Training Standards. Employers/Sponsors are expected to extend the apprentice's knowledge and skills through practical training on the work site.|--Document.

This Book was ranked at 26 by Google Books for keyword display kiezen voor academic service.

Book ID of General Machinist's Books is YvQrPwAACAAJ, Book which was written byOntario. Ministry of Training, Colleges and Universitieshave ETAG "Y/usw4y93xk"

Book which was published by since 2008-01-01 have ISBNs, ISBN 13 Code is 9781424968428 and ISBN 10 Code is 1424968429

Reading Mode in Text Status is false and Reading Mode in Image Status is false

Book which have "55 Pages" is Printed at BOOK under CategoryApprentices

This Book was rated by Raters and have average rate at ""

This eBook Maturity (Adult Book) status is NOT_MATURE

Book was written in en

eBook Version Availability Status at PDF is falseand in ePub is false

Book Preview